Integrator Assembly - Christie CP42LH Service Manual

11. Remove the heat dump.
12. Disconnect the LAD fan connection from the EVB card.
13. Remove the Light engine quick disconnect
14. Loosen the 3 captive screws securing the light engine.
15. Carefully lift the light engine assembly out of the projector with the handle.
Replacement
1. To complete the installation, follow the removal steps in reverse order.
2. Adjust convergence, as described in
3. Adjust appropriate optical items described in

Integrator assembly

Wear the gloves provided in the Service Kit when handling the integrator. Failure to comply
may result in equipment damage.
Estimated replacement time: 12 minutes + 30 minutes for calibration
1. Remove the Front top
2. Remove the Rear top
3. Open the Optical access
4. Disconnect the integrator and diffuser temperature sensor connectors.
5. Remove the 2 screws securing the diffuser cooling connection.
6. Remove the 2 screws from the relay lens cover.
7. Remove the 2 screws securing the integrator clamp.
CP42LH Service Manual
020-101686-03 Rev. 1 (08-2016)
on page 68.
Adjust DMD convergence
lid, see page 41.
lid, see page 42.
door, see page 43.
Parts and Module Replacement
on page 31.
Adjust the Image, see page 26.
59