Christie CP2210 Service Manual page 119

EXAMPLES:
(SIN?) Get current input port
(SIN?L) Show entries on the list
(SIN 1) Set current input port to entry with index 1
(SIN+C101 ?) Get input port on channel 101
(SIN+C101 1) Set input on channel 101
SNMP Agent Configuration (SNM)
This control will set the various configuration options for SNMP Agent
SUBCODE DESCRIPTION OF USE
ENVT
Enables/Disables SNMP version 2 and enables version 3
LEXT
Gets/sets the Lamp Expire Trap Flag for the SNMP Agent
LHLT
Gets/sets the Lamp Half Life Trap Flag for the SNMP Agent
TSIP
Sets the Trap IP address for the SNMP agent
EXAMPLES:
(SNM+TSIP "xxx.xxx.xxx.xxx") Sets the Trap IP address to xxx.xxx.xxx.xxx
(SNM+TSIP "0.0.0.0") Setting the IP address to 0.0.0.0 will stop SNMP Agent from sending the traps.
(SNM+LHLT 1) Setting this flag to 1 will disable any future lamp half life traps
(SNM+LEXT 1) Setting this flag to 1 will disable any future lamp expire traps
(SNM+ENVT ?) Get the flag to see if V2 is enabled (1) or disabled (0)
(SNM+ENVT 1) Enable SNMP V2
(SNM+ENVT 0) Disable SNMP V2
Screen Orientation (SOR)
Set screen orientation. This allows for flipping the screen orientation to allow for various mounting options of the
projector including the use of mirrors and front or rear screen projection.
SUBCODE DESCRIPTION OF USE
NONE
Select Orientation:
0 - Normal Front,
1 - Inverted Rear,
2 - Normal Rear,
3- Inverted Front
EXAMPLES:
(SOR?L) List orientation options
(SOR?) Get the orientation status
(SOR0) Set orientation to front
Select Source Format (SRF)
elect the Source format file.
S
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select source format for the current channel.
EXAMPLES:
(SRF+C108 "XXX") Use file "XXX" on channel 108
(SRF+C108?) Get source file name on channel 108
(SRF?L) List all entries of source control
(SRF+RFSH 1) Refresh TI file list
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Section 7: Serial API
7-19