Upgrading Main Software; Steps To Install An Upgrade Package - Christie CP2210 Service Manual

Section 3: Service Setup
3.7

Upgrading Main Software

The Upgrade window begins a series of steps to walk you through the upgrade process. You must login as an
Admin level or higher to use the upgrade feature. The left column of the Upgrade window shows which state
you're currently at in the upgrade process. Click the Next/Prev buttons to navigate the series of steps.

3.7.1 Steps to Install an Upgrade Package

1. Ensure you are logged in at the service level.
2. Access the Upgrade Package using 1 of the following processes:
• Insert the USB drive containing the upgrade package into the USB port on the TPC. Navigate to the
Administrator Setup: Upgrade window and click the Upload button. (Figure 3-8). This launches a
file selection dialog for you to navigate and select this file. Once complete, the system automatically
advances to the Extraction window and begins extracting the upgrade package.
• From an FTP client, enter the projector IP address and enter the user name and password. Once con-
nected, copy the upgrade package from the FTP site to the root folder of the projector. The upgrade pack-
age should display in the Available Upgrade Files region of the File Selection window (Figure 3-8).
Select the upgrade package and click the Next button to advance to the Extraction window. NOTE:
After copying several upgrade packages to the root folder, an alarm will occur if the disk space becomes
full. Navigate to the root folder and delete the older upgrade packages. Once removed, copy the current
upgrade package again.
3. The Extraction window shows the progress of extracting, decrypting, and verifying the files. On any
failure, the upgrade process will display an error dialog and then bring you back to the File Selection
window. On successful extraction of the package, the upgrade process will automatically advance to the
Package Details window. Once the extraction is complete, you can remove the USB drive.
4. The Package Details window shows the versions of all components installed in the projector (Figure 3-9).
Select the type of install to perform: Upgrade Different Components Only, Force Upgrade All, or
Factory Defaults Install and click the Next button to advance to the Installation window.
5. The Installation window displays the state of the upgrade progress (Figure 3-10). On successful
completion or failure of the installation, a dialog will display indicating the state of the upgrade. Click the
OK button. At this point, the TPC will reboot in order to install the TPC user interface software. The TPC
will shut down, reboot, and display an install progress window as the user interface is installed. Once
complete, click the Finish button to return to the Main panel.
6. Power cycle the projector by turning the breaker OFF and then ON again.
7. Power cycle once more if you have any version mismatch errors.
3-10 CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)