Safety Warnings And Guidelines; Replacement Procedures; Servicing Guidelines; Tools Required - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement
5.3

Safety Warnings and Guidelines

before servicing.
• Once the projector is powered down, allow the cooling fans to automatically turn OFF
before disconnecting from AC and opening the projector. This takes approximately 15
minutes.
• All module replacement procedures must be performed by Christie authorized service
technicians.
handling electronic assemblies. Gloves are required when handling critical optical
components.
5.4

Replacement Procedures

5.4.1 Servicing Guidelines

• Follow all service safety warning and guidelines.
• Refer to Section 5.2 Index of Parts and Modules
module within the projector.
• When re-installing a module, follow "removal" instructions in reverse unless otherwise indicated.
• Refer to Section 6 Interconnections

5.4.2 Tools Required

• Low and high security keys
• Phillips screwdrivers - #1, #2 and #3 long stems
™
• Hex Keys/Drivers - 2.5mm, 3mm, 4mm and 5mm
• Wrench - 17mm and 19mm
• Electrostatic protective strap and pad
• Disposable Nitrile gloves
5-4
Always power down and disengage all power sources from the projector
Observe all electrostatic precautions. Use a grounded wrist strap when
when re-connecting harnesses.
(included with optical components)
along with Appendix C: Exploded Views to locate each
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)