Fold Mirror 1 - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement
7. Reverse the above steps to install the cold mirror. NOTE: When installing, ensure that the reflective
surface faces inwards (Figure 5-73).
8. LampLOC™ and MCGD must be calibrated after installation. For details, refer to the CP2210 User
Manual (P/N: 020-100410-xx).

5.6.14 Fold Mirror 1

NOTICE: Wear gloves when handling the fold mirror.
(Estimated Replacement Time: 20 minutes; includes 10 minute calibration)
Fold Mirror 1 is accessed from the front left-corner of the projector. The alignment screws are positioned along
the top of the light tube, which allows them to be easily adjusted.
1. Remove the top lid. Refer to
2. Remove the side skin service door. Refer to
3. Remove the contrast aperture. Refer to
4. Remove the light sensor module. Refer to
5. Loosen the 2.5mm locking hex screw and remove the two 2.5mm hex screws securing fold mirror 1 to the
bracket (Figure 5-74).
6. Remove fold mirror 1.
7. Reverse the above steps to install fold mirror. NOTE: When installing, ensure that the reflective surface
faces inwards (Figure 5-75).
5-50
Figure 5-73 Installing Cold Mirror
5.5.5 Top Lid, on page
5.6.11 Contrast Aperture, on page
Figure 5-74 Fold Mirror
5-7.
5.5.11 Exhaust Panel Skin, on page
5.6.12 Light Sensor Module, on page
A 2.5mm Locking Hex Screw
B Hex Screw (1 of 2)
5-10.
5-48.
5-48.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)