Lamp Blower Assembly - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement

5.5.18 Lamp Blower Assembly

UV HAZARD! Always wear protective safety clothing and a face shield when performing
service with the service safety shield removed and a lamp installed.
The lamp blower assembly is located at the rear of the projector, beside the lamp adjust module. It is held in
place by two captive screws. It easily lifts straight up out of the projector.
(Estimated Replacement Time: 20 minutes)
1. Open the lamp door. Refer to
2. Remove the lamp (if installed). Refer to
3. Remove the top lid. Refer to
4. Open the safety shield. Refer to
5. Remove the standby power supply. Refer to
6. Loosen the three captive screws (Figure 5-20).
7. Lift the lamp blower assembly up to disconnect the two
lamp blower harnesses. Refer to
tions. When disconnecting, ensure that the center tab on
the harness is pressed down before pulling out.
Improperly disconnecting could cause the actual harness
connectors to come loose.
8. Lift the assembly out of the projector housing (Figure 5-
21).
5-16
5.5.10 Lamp Door, on page
5.5.15 Lamp Replacement, on page
5.5.5 Top Lid, on page 5-7.
5.5.12 Safety Shield, on page
5.5.19 Standby Power Supply, on page
Figure 5-20 Loosen Captive Screws
Section 6 Interconnec-
5-9.
5-13.
5-10.
Figure 5-21 Remove Lamp Blower
5-17.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)