Reflector Assembly (Including Heat Dump) - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement

5.5.24 Reflector Assembly (Including Heat Dump)

UV HAZARD! Always wear protective safety clothing and a face shield when performing
service with the safety shield removed and a lamp installed.
(Estimated Replacement Time: 60 minutes + 10 minute LampLOC
1. Remove the top lid. Refer to
2. Remove the safety shield. Refer to
3. Remove the lamp (if installed). Refer to
4. Using a 5mm hex key, remove the four screws securing the reflector. Three of these screws are located on
the bracket outside the reflector. The fourth screw is located inside the casing below the reflector (Figure
5-33).
5. Carefully lift the reflector assembly straight up and out of the unit, being careful not to touch the UV filter
glass.
6. Remove the two M3 screws securing the lamp temperature sensor to the lamp cover (Figure 5-34).
7. Remove the two M3 screws securing the
sensor to the cover (Figure 5-34).
8. Use a #2 Phillips
securing the front lamp cover.
9. Reverse the above steps to reinstall. Perform
LampLOC
™
the CP2210 User Manual (P/N: 020-
100410-xx).
5-24
5.5.5 Top Lid, on page
5.5.12 Safety Shield, on page
Figure 5-33 Remove Reflector
to remove the 13 screws
™
alignment. For details, refer to
5-7.
5.5.15 Lamp Replacement, on page
Figure 5-34 Front Lamp Cover & Lamp Shield
Alignment)
™
5-10.
5-13.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)