3: Service Setup; Alignment Procedures - Christie CP2210 Service Manual

3 Service Setup
This section describes special internal hardware adjustments and related details that may require the
attention of a Christie authorized service technician, whether done periodically or after a specific
module replacement. When combined with the range of installation and setup information provided in
the CP2210 User Manual (P/N: 020-100410-xx) the projector can be up-and-running at its full
potential after service or relocation.
3.1

Alignment Procedures

Table 3.1 Alignments/Procedures
Part Description
Ceramic Plate (on Douser blade)
Cold Mirror
Douser Motor
Fold Mirror
Illumination Optics System (IOS)
Integrator Assembly
Lamp
Lamp Power Supply (LPS)
Lens Mount Kit (Motorized or Non-Motorized)
Light Engine
Reflectors, 12" Glass
UV Filter
Yellow Notch Filter
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Required Alignments/Procedures
• Adjust LampLOC ™
™
• Adjust LampLOC
• Recalibrate Measured Color Gamut Data (MCGD)
™
• Adjust LampLOC
• Adjust Fold Mirror alignment
• Adjust Yellow Notch Filter
• Recalibrate color
• Define footlamberts (optional)
• Integrator alignment
• Fold Mirror alignment
• Adjust LampLOC ™
™
• Adjust LampLOC
• Boresight adjustment
• Recalibrate color
• Define footlamberts (optional)
™
• Adjust LampLOC
™
• Adjust LampLOC
• Adjust YNF screw for accurate green coordinates
• Recalibrate color
3-1