Cardcage Panel Skin; Rear Access Door Skin - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement

5.5.7 Cardcage Panel Skin

The cardcage panel is on the right-side of the projector. Most service procedures performed on this side of the
projector are typically done by removing the cardcage; therefore, removal of this panel is unlikely unless it is
damaged and requires replacement.
(Estimated Replacement Time: 45 minutes)
1. Remove the top lid. Refer to
2. Remove the cardcage. Refer to
on page 5-36.
3. Using a #2 Phillips
front of the cardcage.
4. Use a 4mm hex key to remove the four screws securing
the skin to the corner brackets.
5. Use a 4mm hex key to remove the five socket head cap
screws along the bottom edge of the skin
(Figure 5-7).
6. Pull the cardcage panel out.
7. Reverse the above steps to re-install. NOTE: Ensure
that the front and rear corners interlock before reinstall-
ing screws.

5.5.8 Rear Access Door Skin

The rear access frame interlocks with the side skins. This skin
should never need to be removed unless it is damaged and
requires replacement.
(Estimated Replacement Time: 6 minutes)
1. Remove the top lid. Refer to
2. Remove the TPC. Refer to
(TPC), on page
3. Remove the exhaust panel skin. Refer to
Panel Skin, on page
4. Use a 4mm hex key to remove the five socket head cap
screws along the bottom edge of the projector (Figure 5-
8).
5. Use a #2 Phillips
6. Pull the skin forward and out.
5-8
5.5.5 Top Lid, on page
5.6.1 Cardcage Module,
, remove the two screws from the
™
5.5.5 Top Lid, on page
5.5.4 Touch Panel Controller
5-6.
5-10.
to remove the two screws from the AC receptacle.
™
5-7.
Figure 5-7 Remove Cardcage Panel
5-7.
5.5.11 Exhaust
Figure 5-8 Remove Rear Access Door Skin
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)