Table of Contents
Advertisement
3. Remove the snood.
4. To install the snood, repeat these steps in reverse order.
Replacing the integrator assembly
Estimated replacement time: 5 minutes + 15 minute calibration
Warning! Failure to comply with the following could result in death or serious injury.
•
UV EXPOSURE! Protective UV safety glasses with side shields and Christie approved protective
safety clothing must be worn when performing optical adjustments or servicing the product.
1. Remove the front top lid (on page 40).
2. Remove the snood (on page 40).
3. Remove the two screws securing the retaining clip to the rear end of the integrator.
Avoid damaging the temperature sensor.
4. Wearing the gloves provided with the service kit, carefully remove the integrator assembly
and set aside in a clean area where it cannot be damaged.
5. To complete the installation, repeat these steps in reverse order.
6. Adjust the integrator (on page 25).
7. Adjust the fold mirror (on page 24).
Replacing the light sensor module
Estimated Replacement Time: 10 minutes
1. Remove the front top lid (on page 40).
2. Disconnect the light sensor module (LSM) harness from the inline connector.
3. Remove the radiator.
4. Remove the two screws securing the LSM bracket to the IOS.
5. Remove the one screw securing the LSM to the bracket.
6. To install the light sensor module, repeat these steps in reverse order.
7. Power up the projector and re-calibrate the light sensor module.
Replacing the UV filter
Estimated replacement time: 11 minutes + 10 minute calibration
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Parts and module replacement
67
Advertisement
Table of Contents
