Ac Line Filter - Christie CP2210 Service Manual

110V AC Line Filter
UV HAZARD! Always wear protective safety clothing and a face shield when performing
service with the safety shield removed and a lamp installed.
1. Disconnect the AC power cord.
2. Unlock the rear access door.
3. Remove the top lid. Refer to
4. Remove the safety shield. Refer to
5. Open the lamp door. Refer to
6. Remove the two M5 screws securing the AC line filter on the inside of the projector housing.
(Figure 5-50)
7. Remove the two M3 screws securing the AC line filter on the outside of the projector housing.
(Figure 5-50)
8. Disconnect the two harnesses from the 110V AC line filter. (Figure 5-49, B)
9. Use a #1 Phillips
10. Reverse the above steps to install the 110V AC line filter.
220V AC Line Filter
UV HAZARD! Always wear protective safety clothing and a face shield when performing
service with the safety shield removed and a lamp installed.
1. Disconnect the AC power cord.
2. Unlock the rear access door.
3. Remove the top lid. Refer to
4. Remove the safety shield. Refer to
5. Open the lamp door. Refer to
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
5.5.5 Top Lid, on page
5.5.12 Safety Shield, on page
5.5.10 Lamp Door, on page
Figure 5-50 Remove AC Line Filter
to remove the two screws securing the AC line filter to the rear skin frame.
™
5.5.5 Top Lid, on page
5.5.12 Safety Shield, on page
5.5.10 Lamp Door, on page
Section 5: Parts and Module Replacement
5-7.
5-10.
5-9.
5-7.
5-10.
5-9.
5-35