Christie CP2210 Service Manual page 116

Section 7: Serial API
Network Setup (NET)
Set the network parameters for Eth0, Gateway, and Subnet 0.
SUBCODE DESCRIPTION OF USE
DLP0
Set the IP address for the MGMT Ethernet controller (deprecated).
ETH0
Set the WAN IP address for the projector
GATE
Set the WAN Gateway for the projector
HOST
Host name
MAC0
Gets the MAC address of the projector
SUB0
Set the WAN subnet mask for the projector
EXAMPLES:
(NET+ETH0 "192.168.1.35") Set new IP address on the MGMT Ethernet controller
(NET+GATE "192.168.0.1") Set the gateway
(NET+SUB0 "255.255.255.0") Set the subnet mask on the MGMT Ethernet controller
(NET+HOST "MyHostName") Set the host name
(NET+ETH0 ?) Retrieve IP address from the MGMT Ethernet controller. (NET+ETH0! 192.168.1.35)
(NET+MAC0 ?) Retrieve MAC address from MGMT controller. (NET+MAC0! 00:12:3F:7B:76:B4)
(NET+GATE ?) Retrieve default gateway. (NET+GATE! 192.168.0.1)
(NET+DLP0 "192.168.206.10") Set IP address (deprecated)
(NET+DLP0?) (NET+DLP0! "192.168.206.10") Query IP address (deprecated)
Projector Configuration File (PCF)
Set Projector Configuration File (PCF) file for the specified channel. This file is used to configure many aspects of
the cinema electronics. It will only be used if PCF in use (PIU) control is set.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select PCF file for the current channel
EXAMPLES:
(PCF+C108 "SCOPE 2.39") Use PCF file "Scope 2.39" on channel 108. File used when PIU is on
(PCF?L) List all entries of PCF control
PCF In Use (PIU)
Select whether to use the PCF file or not.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select "Use PCF" for the current channel
EXAMPLES:
(PIU?) Get the current status of PCF file
(PIU+C108 1) Use PCF file on channel 108
(PIU+C108 0) Do not use PCF file on channel 108
7-16 CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)