Side Skin Service Door; Lamp Door - Christie CP2210 Service Manual

5.5.9 Side Skin Service Door

The side skin service door allows access to the Low Voltage Power Supply (LVPS), Radiator Filter, Integrator,
Fold Mirror and Liquid Cooling assemblies.
(Estimated Replacement Time: 10 minutes)
1. Remove the top lid. For details, refer to
Top Lid, on page
2. Use a #2 Phillips
two screws from the inside of the door (Figure
5-9).
3. To remove the door disengage the skin from the
two snap tabs.
4. Reverse the above steps to re-install the skin.

5.5.10 Lamp Door

UV HAZARD! Wear authorized protec-
tive clothing (P/N:598900-095) whenever
the internal lamp door is opened.
Located on the inside of the rear access door is a
duct for transporting air from the blower to the lamp
compartment and a 5mm hex key to tighten/loosen
the lamp cathode clamp.
(Estimated Replacement Time: 40 minutes)
1. Unlock the rear door using the low security key.
2. Remove the c-clip from the right-side hinge of the rear door (Figure 5-10/B).
3. Slide the pivot rod out from the left-side (Figure 5-10/A).
4. Reverse the above steps to reinstall. NOTE: When replacing the lamp door ensure the airflow duct and
hex key holder are removed and installed onto the replacement door.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
5-7.
screwdriver to remove the
™
Figure 5-10 Remove Lamp Door
Section 5: Parts and Module Replacement
5.5.5
Figure 5-9 Side Skin Service Door
A
B
Pivot Rod
C-Clip
5-9