Removing The Service Door - Christie CP2208 Service Manual

8. Remove the nut and washer securing the ground lug to the projector and then remove the
ground lug.
9. Open the lamp door.
10. Loosen the five top skin screws.
11. Pull the skin forward and out.

Removing the service door

The side skin service door allows access to the Low Voltage Power Supply (LVPS), integrator, fold
mirror, and light engine air filter.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Reach into the projector and then loosen the first service panel screw.
4. Open the integrator rod access door and loosen the second service panel screw.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid
Parts and Module Replacement
on page 33.
38