Remove The Service Door - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement
7. Remove the five screws from the bottom edge of the skin.
8. Remove the screw from the AC receptacle.
9. Remove the nut and washer securing the ground lug to the projector and then remove the ground lug.
10. Open the lamp door.
11. Loosen the 5 top skin screws.
12. Pull the skin forward and out.
3.11

Remove the Service Door

The side skin service door allows access to the Low Voltage Power Supply (LVPS), integrator, fold mirror, and
light engine air filter.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Reach into the projector and then loosen the first service panel screw.
3-8
Remove the Top Lid on page 3-4.
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)