Removing The Service Door; Removing The Front Skin - Christie CP2208-LP Service Manual

3. To install the top skin, repeat these steps in reverse order.

Removing the service door

The service door provides access to the light engine air filter.
Estimated replacement time: 1 minute
1. Remove the two screws from the service door.
2. Pull the door out from the projector.
3. To re-install, complete these steps in reverse order.

Removing the front skin

The front skin provides access to the lens mount assembly and card cage intake fans.
Estimated replacement time: 8 minutes
1. Turn off the projector and disconnect it from AC power.
2. Remove the top skin (on page 32).
3. Loosen the two captive screws on the bottom of the card cage air filter cover.
4. Pull the cover out and down.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Projector covers and feet
33