Timers Lsa-Group-Pacing; Timers Spf - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Description
Defaults
Instructionsbbs
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
<ip-address>
<net-mask>
OSPF has no summary address.
� This command is supported after the platform version 4.6.02.
� It is allowed to summarize multiple groups of addresses for a
specified level and routes obtained from other routing proto-
cols. The measurement metric for advertising summary paths
is the minimum one among all of the more detailed paths. This
command helps to reduce the size of the routing table.
This example makes a summary of static routes 10.1.1.0/24,
10.1.2.0/24 and 10.1.3.0/24 into one route and redistribute it to
OSPF.
ZXR10(config)#router ospf 1
ZXR10(config-router)#summary-address 10.1.0.0 255.255.0.0

timers lsa-group-pacing

Use this command to specify the time interval of OSPF lsa-group-
pacing. Use the no form of this command to make OSPF lsa-group-
pacing restore the default value.
Router configuration
timers lsa-group-pacing <seconds>
no timers lsa-group-pacing
<seconds>
This command is supported after the platform version 4.6.02.
This example sets time interval of OSPF lsa-group-pacing as 2 sec-
onds.
ZXR10(config)#router ospf 1
ZXR10(config-router)#timer lsa-group-pacing 2

timers spf

Use this command to specify the minimum time interval between
two continual SPF computations. Use the no form of this command
to make it restore the default value.
Router configuration
timers spf <spf-holdtime>
Confidential and Proprietary Information of ZTE CORPORATION
IP address, in the form of dotted decimal
IP subnet mask for the summary path, in the
form of dotted decimal
Time interval of OSPF lsa-group— pacing,
unit: second, range: 1~2, default: 1 second
Chapter 3 OSPF Protocol
95