Validate-Update-Source; Version - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
28 Confidential and Proprietary Information of ZTE CORPORATION
Caution:
If the update period is too short, it may cause congestion in the
low-speed serial line. while it will not cause big problems in the
high-speed serial line of the fast Ethernet. In addition, if there are
many routes to be updated, it may cost the router a great deal of
time to handle the update route.
In the following example, the update information is broadcast ev-
ery 5 seconds. If the router does not receive the information in
15 seconds, it will make an advertisement that the route is un-
reachable. The remaining information will be suppressed in the
subsequent 15 seconds. The route entry will be cleared from the
routing table after the suppression period.
ZXR10(config)#router rip
ZXR10(config-router)#timers basic 5 15 15 30

validate-update-source

Use this command to start the function to check whether the
source IP addresses of received RIP update packets are effective.
Disable this function with the no form of this command.
Router configuration and address family configuration

validate-update-source

no validate-update-source
This command is enabled by default.
The command is started to check the source IP addresses of RIP
update packets from the interface. The packets will be received
only if the source IP addresses are in the same subnet as the in-
terface address.
This example configures the router which does not check the
source IP addresses of RIP update packets.
ZXR10(config)#router rip
ZXR10(config-router)#network 128.105.0.0
ZXR10(config-router)#no validate-update-source

version

Use this command to specify the version of RIP routers globally
use. Restore default with the no form of this command.
Router configuration and address family configuration

version {1 | 2}

no version