Setting Port Unkown Source Mac Address Filtering; Setting Mac Address Filtering - Zte ZXR10 5900E Series User Manual

St- Command
ep
1
mac protect [interface <port-name
ZXR10(config)#
>]{disable|enable}
2 mac protect time <time>
ZXR10(config)#
Command
mac unknowsource-filter interface
ZXR10(config)#
<port-name>{disable|enable}
Command
mac filter {source|both|destination}<m
ZXR10(config)#
ac-address> vlan <vlan-id>
The detailed configuration is as follows:
MAC address learning protection is disabled on all switch ports by
default. To enable this function, it is recommended to set a smaller
MAC address count limit.
Setting Port Unkown Source MAC
Address Filtering
By default, the port unkown source MAC address filtering function
is closed. A port does not filter unkown source MAC address. If one
port enables unkown source MAC address filtering function, the
corresponding port will discard the unkown source MAC address
packets from this port.
To set port unkown source MAC address filtering on a port, use the
following command.

Setting MAC Address Filtering

To prevent unauthorized access, ZXR10 5900E support filtering
data frames according to MAC addresses. There are three filtering
modes:
� Source MAC address matching only, that is, a data frame is
dropped when its source MAC address matches the setting.
� Destination MAC address matching only, that is, a data frame is
dropped when its destination MAC address matches the setting.
� Source/Destination MAC address matching, that is, a data
frame is dropped when its source or destination MAC address
matches the setting.
To set MAC address filtering, use the following command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 MAC Address Table Configuration
Function
This sets port MAC address
learning protection.
This sets port MAC address
learning protection time.
Function
This sets port unkown source
MAC address filtering on a port.
Function
This sets MAC address filtering.
33