Reset Confirmation Window - Silicon Graphics Origin 3900 User Manual

8: System Control
Reset Confirmation Window
124
If you press the RESET button in the home window, the reset confirmation window
appears, as shown in Figure 8-9.
To initiate the reset command, press the OK button. To terminate the command, press
the Cancel button. The confirmation window stays visible until the command is
successfully executed. An unsuccessful command results from an L1/L2 error in
processing the command or a time-out while waiting for a response.
SGI L2 Controller, Firmware xx.xx.x
L2-001 S/N Nxxxxxxx [System name]
Power: ON
Press the "OK" button to issue the
"r * s * reset" command.
OK
Figure 8-9 Reset Confirmation Window
Note: The reset command affects all bricks in the targeted partition(s). The target list
is not enforced during the processing of a reset command.
Cancel
007-4653-001