Viewing System Configuration - Silicon Graphics Origin 3900 User Manual

Viewing System Configuration
007-4653-001
You can use the L2 config command to view the current system configuration from a
brick level:
L2> config
L2 127.0.0.1: - 001 (LOCAL)
L1 127.0.0.1:0:5 - 001c19
L1 127.0.0.1:0:0 - 001c15
L1 127.0.0.1:1:5 - 001c11
L1 127.0.0.1:1:0 - 001c07
L1 127.0.0.1:1:1 - 001i23
L2>
As shown above, config produces a list of bricks and their locations in the system and
the system controller address of each brick. This is similar to the output from using the
config command on the L1 controller with the addition of the IP address of the L2
controller and USB port number. The structure of the brick's address is as follows:
a.b.c.d:x:y
where:
a.b.c.d is the IP address of the L2 controller. (In the example above, the IP
address is 127.0.0.1.)
x is the USB port number.
y is the L1 index, as follows:
0 is the local brick (the brick to which the USB cable is attached).
A number greater than 0 indicates that the brick is attached to the local
brick. For example, an I/O brick that connects to an XIO port of the
local Cx-brick has a number of 1, 2, 3, or 4. The Cx-brick that connects to
the local Cx-brick via ports A and F has a number of 5.
Operating L2 Controller
133