Power Up Confirmation Window - Silicon Graphics Origin 3900 User Manual

8: System Control
Power Up Confirmation Window
122
If you press the Power UP button in the home window, the power up confirmation
window appears, as shown in Figure 8-7.
To initiate the power up command, press the OK button. To terminate the command,
press the Cancel button. The confirmation window stays visible until the command is
successfully executed. An unsuccessful command results from an L1/L2 error in
processing the command or a time-out while waiting for a response.
SGI L2 Controller, Firmware xx.xx.x
L2-001 S/N Nxxxxxxx [System name]
Power: OFF
Press the "OK" button to issue the
"r * s * power up" command.
OK
Figure 8-7 Power Up Confirmation Window
The power up command affects only the list of bricks identified in the destination field.
To set or change the target list, press the Cancel button to return to the home window.
Then press the DEST: button to change the target list. See "Destination Selection
Window" on page 127 for instructions on using the DEST: button.
Cancel
007-4653-001