Replacing Tp900 Drive Carrier Module - Silicon Graphics Origin 3900 User Manual

Replacing TP900 Drive Carrier Module

!
!
!
007-4653-001
Caution: Follow electrostatic discharge (ESD) precautions while replacing the drive
carriers. Avoid contact with the backplane components and module connectors.
To replace a drive carrier module from the TP900 enclosure, follow these steps:
Caution: Do not remove a drive carrier unless a replacement or a dummy carrier can be
immediately added. The system must not be run without all modules in place. Any
unused drive bays must be fitted with a dummy carrier module.
1. Using the operating system, spin down the drive prior to removal.
Caution: Damage can occur to a drive if it is removed while still spinning. If you
cannot use the operating system to spin down the drives prior to removal, perform
all steps of the following procedure to ensure that the drive has stopped prior to
removal.
Installing or Replacing TP900 Drive Carrier Module
219