Figure 14-21 Removing Drive Carrier Module - Silicon Graphics Origin 3900 User Manual

!
007-4653-001
4. Open the handle by pressing the latch on the module handle towards the right.
Then gently slide the module out of the enclosure approximately 1 inch (25 mm),
and wait 30 seconds for the drive to stop spinning. See Figure 14-21.
Caution: Damage can occur to a drive if it is removed while still spinning.
s g i
s g i
s g i
Figure 14-21 Removing Drive Carrier Module
5. After 30 seconds, withdraw the module from the drive bay. Replace it immediately;
follow the instructions in "Installing D-brick2 Drive Carrier Module" on page 221.
Installing or Replacing D-brick2 Drive Carrier Module
s g i s g i s g i
s g i
s g i
s g i
s g i
227