Operating L1 Controller; L1 Mode - Silicon Graphics Origin 3900 User Manual

8: System Control

Operating L1 Controller

L1 Mode

110
The L1 controller operates in one of two modes: L1 mode or console mode. In L1 mode,
the L1 prompt is visible and all input is directed to the L1 command processor. In console
mode, the output from the system is visible and all input is directed to the system.
Note: Console mode is supported only if the system console is connected directly to the
console port of a Cx-brick. Under normal conditions, the system console is connected to
the L2 controller.
If you see a prompt of the following form, the L1 is ready to accept commands.
001c07-L1>
Common operations are discussed in the following sections:
• "Viewing System Configuration" on page 111
• "Targeting Commands" on page 112
• "Viewing Information, Warnings, and Error Messages" on page 112
• "Powering On, Powering Off, and Resetting Brick" on page 113
007-4653-001