Power Down Confirmation Window - Silicon Graphics Origin 3900 User Manual

Power Down Confirmation Window
007-4653-001
If you press the Power DOWN button in the home window, the power down
confirmation window appears, as shown in Figure 8-8.
To initiate the power down command, press the OK button. To terminate the command,
press the Cancel button. The confirmation window stays visible until the command is
successfully executed. An unsuccessful command results from an L1/L2 error in
processing the command or a time-out while waiting for a response.
SGI L2 Controller, Firmware xx.xx.x
L2-001 S/N Nxxxxxxx [System name]
Power: ON
Press the "OK" button to issue the
"r * s * power down" command.
OK
Figure 8-8 Power Down Confirmation Window
The power down command affects only the list of bricks identified in the destination
field. To set or change the target list, press the Cancel button to return to the home
window. Then press the DEST: button to change the target list. See "Destination Selection
Window" on page 127 for instructions on using the DEST: button.
Cancel
L2 Controller
123