Powering On, Powering Off, And Resetting Brick; Console Mode - Silicon Graphics Origin 3900 User Manual

Powering On, Powering Off, and Resetting Brick

Console Mode

007-4653-001
You can power on, power off, or reset a brick with L1 commands. The L1 command to
power on a brick is power up or pwr u. The L1 command to power off a brick is power
down or pwr d. The L1 command to reset a brick is reset.
When you prefix the power up, power down, or reset command with an asterisk (*), you
can power on, power off, or reset the entire system.
001c07-L1> * power up
001c07-L1>
Note: These commands can require from several seconds to several minutes to complete.
In console mode, output from the system is visible and all input is directed to the system.
To enter console mode, press Ctrl+D at the L1 prompt:
001c07-L1> Ctrl+D
entering console mode 001c07 console, <CTRL-T> to escape to L1
.
<system output appears here>
.
To return to L1 mode, press Ctrl+T:
Ctrl+T
escaping to L1 system controller
001c07-L1>
While in L1 mode, you can enter any L1 command. Once the command is executed, the
L1 returns to console mode:
re-entering console mode 001c07 console, <CTRL-T> to escape to L1
To permanently engage the L1 mode, press Ctrl+T and then enter the l1 command:
Ctrl+T
escaping to L1 system controller
001c07-L1> l1
L1 command processor engaged, <CTRL-D> for console mode.
001c07-L1>
Operating L1 Controller
113