Using Grounding Wrist Strap; Identifying Customer-Replaceable Units; Table 14-1 Customer-Replaceable Components And Maintenance Procedures - Silicon Graphics Origin 3900 User Manual

Using Grounding Wrist Strap

!

Identifying Customer-replaceable Units

!
007-4653-001
Caution: The components inside the server are extremely sensitive to static electricity.
Always wear a wrist strap when you work with parts inside your server.
To use the wrist strap, follow these steps:
1. Unroll the first two folds of the band.
2. Wrap the exposed adhesive side firmly around your wrist, unroll the rest of the
band, and then peel the liner from the copper foil at the opposite end.
3. Attach the copper foil to an exposed electrical ground, such as a metal part of the
chassis.
Caution: Do not attempt to install or remove components that are not listed in
Table 14-1. Components not listed must be installed or removed by a qualified SGI
system support engineer.
Table 14-1 lists the customer-replaceable components and the page on which you can
find the instructions for installing or removing the component.
Customer-replaceable Components and Maintenance Procedures
Table 14-1
Component
PCI and PCI-X cards
IX-brick disk drives
TP900 drive carrier modules
D-brick2 drive carrier modules "Installing or Replacing D-brick2 Drive Carrier Module" on
Maintenance Precautions and Procedures
Procedure
"Installing or Replacing PCI or PCI-X Card" on page 202
"Installing or Replacing Disk Drives in IX-brick" on page 211
"Installing or Replacing TP900 Drive Carrier Module" on
page 216
page 221
201