Viewing System Configuration - Silicon Graphics Origin 3900 User Manual

Viewing System Configuration
007-4653-001
An L1 controller has limited knowledge of the system configuration. A Cx-brick only has
information about its attached I/O brick and, if another Cx-brick is attached to it,
information about that Cx-brick and its attached I/O brick. An I/O brick only has
information about its attached Cx-brick. An R-brick only has information about itself.
You can view a brick's configuration information with the config command:
001c07-L1> config
:0 - 001c07
:1 - 001i23
:2 - 001p11
001c07-L1>
This example is a system with one Cx-brick and two I/O-bricks. The <number> that
follows the colon (0, 1, 2, and 3, from top to bottom in this example), refers to the L1
connection relative to the local brick. (The local brick is the brick that is processing the
command.) For example, ":0" is the local brick. A number greater than 0 indicates that it
is attached directly to or indirectly to the local brick.
Operating L1 Controller
111