Table 3-46: Ip Group Parameters Description; Figure 3-84: Ip Group Table - AudioCodes MediaPack MP-124 User Manual

Notes:
To configure IP Groups, take these 4 steps:
1. Open the 'IP Group Table' page (Configuration tab > Protocol Configuration menu
> Hunt/IP Group submenu > IP Group Table page item).
2. Configure the IP group parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 207.
Parameter
IP Group ID
Description
Proxy Set ID
SIP Group Name
SIP User's Manual
•
By default, if you disable the use of a proxy (i.e., IsProxyUsed is set to 0),
then only one IP Group is defined (and working with multiple IP Groups is
not valid).
•
You can also configure the IP Groups table using the ini file table
parameter IPGroup (refer to ''SIP Configuration Parameters'' on page
258).
Figure 3-84: IP Group Table Page

Table 3-46: IP Group Parameters Description

The identifying number of the IP Group.
The range is 1-9.
Brief string description of the IP Group.
The value range is a string of up to 29 characters. The default is an empty
field.
Selects the Proxy Set ID to be associated with the IP Group. All INVITE
messages configured to be 'sent' to the specific IP Group are physically
sent to the IP address associated with the Proxy Set.
The range is 0-5, where 0 is the default Proxy Set.
Note: To configure Proxy Set ID's, refer to ''Proxy Sets Table'' on page
117.
The request URI host name used in INVITE and REGISTER messages. If
not specified, the value of the global parameter ProxyName (refer to
''Proxy & Registration Parameters'' on page 110) is used instead.
The value range is a string of up to 49 characters. The default is an empty
field.
Description
184
MediaPack Series
Document #: LTRT-65410