Configuration Note
4.3.1.1
Defining Trunk Group Settings
The procedure below describes how to define the Trunk Group's setting. This defines the method
for which IP-to-Tel calls are assigned to the Trunk Group's channel.
To define the Trunk Group settings:
1.
Open the 'Trunk Group Settings' page (Configuration tab > VoIP menu > Protocol
Configuration submenu > Trunk Group > Trunk Group Settings).
2.
In the 'Trunk Group ID' column, enter the Trunk Group ID that you want to configure.
3.
From the 'Channel Select Mode' drop-down list, select the method for which IP-to-Tel calls
are assigned to channels pertaining to the Trunk Group (i.e. Cyclic Ascending).
4.
From the 'Registration Mode' drop-down list, select 'Per Gateway'.
5.
Click Submit to save your changes
4.3.1.2
Defining the Trunk
The procedure below describes how to define the Trunk parameters.
To define the Trunk:
1.
Open the 'Trunk Settings' page (Configuration tab > VoIP menu > PSTN Settings
submenu > Trunk Settings).
Mediant 1000 MSBG
Figure 4-5: Trunk Group Settings Page
25
4. Configuring Mediant 1000 MSBG
October 2010