Routing; Configuring General Routing Parameters; Configuring Outbound Ip Routing Table - AudioCodes Mediant 500 E-SBC User Manual

User's Manual
24

Routing

This section describes the configuration of call routing rules.
24.1

Configuring General Routing Parameters

The Routing General Parameters page allows you to configure general routing parameters.
For a description of these parameters, see ''Configuration Parameters Reference'' on page
691.

To configure general routing parameters:
1. Open the Routing General Parameters page (Configuration tab > VoIP menu > GW
and IP to IP > Routing > General Parameters).
2. Configure the parameters as required.
3. Click Submit.
24.2

Configuring Outbound IP Routing Table

The Outbound IP Routing table lets you configure up to 180 Tel-to-IP or outbound IP call
routing rules. The device uses these rules to route calls from the Tel or IP to a user-defined
IP destination. You can also configure the device to process the routing rule before or after
it has performed number manipulation, if necessary.
Configuration of Outbound IP Routing rules includes two areas:

Rule: Defines the characteristics of the incoming Tel call (e.g., Trunk Group on which
the call is received).

Action: Defines the action that is done if the incoming call matches the characteristics
of the rule (i.e., routes the call to the specified IP destination).

The device searches the table from top to bottom for the first rule that matches the
characteristics of the incoming call. If it finds a matching rule, it sends the call to the IP
destination configured for that rule. If it doesn't find a matching rule, it rejects the call.
Matching Characteristics: One or more characteristics can be defined for the rule:
Version 6.8 385
24. Routing
Mediant 500 E-SBC