Figure 8-86: Active Directory-Based Routing Rules In Outbound Ip Routing Table - AudioCodes Mediant 600 User Manual

SIP User's Manual
This feature uses the following parameters to configure the attribute names in the AD used
in the LDAP query:

AD attribute for Mediation Server: MSLDAPOCSNumAttributeName (the default is
"msRTCSIPPrimaryUserAddress")

AD attribute for PBX/IP-PBX: MSLDAPPBXNumAttributeName (the default is
"telephoneNumber")

AD attribute for mobile number: MSLDAPMobileNumAttributeName (the default is
"mobile")
Below is an example for configuring AD-based routing rules in the Outbound IP Routing
Table (see ''Configuring Outbound IP Routing Table'' on page 159):

Figure 8-86: Active Directory-based Routing Rules in Outbound IP Routing Table


First rule: sends call to IP-PBX (10.33.45.65) if AD query replies with prefix "PBX:"

Second rule: sends call to OCS client (i.e., Mediation Server at 10.33.45.68) if AD
query replies with prefix "OCS:"

Third rule: sends call to users mobile phone number (to PSTN through the device's IP
address, 10.33.45.100) if AD query replies with prefix "MOBILE:"

Fourth rule: sends call to IP address of device, for example (10.33.45.80) if no
response from LDAP server

Fifth rule: sends query of received Tel destination number to LDAP server, and then
routes the call according to query reply and routing rules at top of table.

Sixth rule: if LDAP functionality is not enabled, routes calls to IP address 10.33.45.72
Therefore, once the device receives the incoming Tel call, the first rule that it uses is the
fifth rule, which queries the AD server. When the AD replies, the device searches the table
from the first rule down for the matching destination phone prefix (i.e., "PBX:", "OCS:",
"MOBILE:", and "LDAP_ERR:"), and then sends the call to the appropriate destination.
Version 6.2 381
8. IP Telephony Capabilities
February 2011