Figure 3-78: Outbound Ip Routing - AudioCodes Mediant 3000 User Manual
Hide thumbs
Also See for Mediant 3000:
- User manual (1070 pages) ,
- Installation manual (90 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
3.3.7.9.3 Configuring the Outbound IP Routing Table
The 'Outbound IP Routing Table' page allows you to configure the device for routing
outbound (i.e., sent) IP-to-IP calls. This table routes inbound IP calls (identified in
''Configuring the Inbound IP Routing Table'' on page 161) received from an IP Group (refer
to ''Configuring the IP Groups'' on page 120) to a specific IP Group destination (or IP
address).
Note:
This table allows you to configure the device's routing rules for sending inbound IP calls
matching some or all of the following criteria to a destination IP address or IP Group:
Source IP Group
Source host prefix
Destination host prefix
Trunk Group
Destination telephone prefix
Source telephone prefix
To configure Outbound IP Routing:
1.
Open the 'Outbound IP Routing Table' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > Tel to IP Routing page item).
2.
From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3.
Configure the Outbound IP Routing table according to the table below.
4.
Click the Submit button to save your changes.
5.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 190.
SIP User's Manual
The 'Outbound IP Routing Table' page appears only if SBC is set to 1 (i.e.,
enabled). If this parameter is not enabled (default), the 'Tel to IP Routing'
page appears instead (refer to ''Configuring the Tel to IP Routing Table'' on
page
151
for a description of this page).
Figure 3-78: Outbound IP Routing Page
156
Mediant 3000
Document #: LTRT-89707
Advertisement
Table of Contents
Troubleshooting
