Routing; Configuring General Routing Parameters; Configuring Outbound Ip Routing Table - AudioCodes Mediant 500 E-SBC User Manual

User's Manual
24

Routing

This section describes the configuration of call routing rules.
24.1

Configuring General Routing Parameters

The Routing General Parameters page allows you to configure general routing parameters.
For a description of these parameters, see ''Configuration Parameters Reference'' on page
673.

To configure general routing parameters:
1. Open the Routing General Parameters page (Configuration tab > VoIP menu > GW
and IP to IP > Routing > General Parameters).
2. Configure the parameters as required.
3. Click Submit.
24.2

Configuring Outbound IP Routing Table

The Outbound IP Routing table lets you configure up to 180 Tel-to-IP or outbound IP call
routing rules. The device uses these rules to route calls from the Tel or IP to a user-defined
IP destination. You can also configure the device to process the routing rule before or after
it has performed number manipulation, if necessary.
The Outbound IP Routing table provides two configuration areas:

Matching Characteristics: Characteristics of the incoming call. If the call
characteristics match a table entry, the routing rule is used to route the call to the
specified destination. One or more characteristics can be defined for the rule:
•
Source IP Group (to which the call belongs)
•
Source and destination Request-URI host name prefix
•
Source Trunk Group (from where the call is received)
•
Source (calling) and destination (called) telephone number prefix and suffix
Version 6.8 379
24. Routing
Mediant 500 E-SBC