Face Up Exit - Konica Minolta 7033 Instruction Manual

Section 10 : Output Mode

Face Up Exit

The 7033 copier basically outputs copies facing down onto the exit tray in simplex copying,
and with the odd number pages facing down in duplex copying.
The Face up exit operates to reverse the above output manner, that is, output copies
facing up in simplex copying and with the odd number pages facing up in duplex copying.
This output mode may reduce the troubles during the output, however, the copied set will
be in reverse order of the originals.
Using Multi-sheet bypass tray automatically sets the copier to be in Face up exit. If you
desire to release this setting, contact your service representative.
Advice
When using platen glass in simplex copying, place the originals in reverse order to get
effective results.
Face Up Exit Specifications
Face up exit can be selected together with Sort, Group, or E-sort exit.
Paper size
Advice
* : A5 size paper is available in horizontal feed (
Incompatible
None
Operation panel
Procedure
1. Press the OUTPUT button to display the Output Mode screen.
2. Touch "
FACE UP ", then " OK " to complete setting and return to the Basic Screen.
Advice
The copier automatically stops to output when the number of copies delivered onto the
exit tray reaches 100 during one output job. If you desire to release this function,
contact your Service Centre.
CAUTION: Maximum Loading Capacity of the Exit Tray
The exit tray capacity is 100 sheets. If a copy run of more than 100 is required,
be sure to remove the copies from the exit tray before the maximum capacity
is reached. Failure to do so will cause the copier to jam.
3. Output Mode for Machine without Finisher
: A3, B4, F4/8.5"x13", A4R, A4, B5R, B5, A5R*,8.5"x11"R,
8.5"x11"
OUT PUT
) only.
Output Mode screen
(continued)
Output Mode
on Exit Tray
10 - 21