Dual Page - Konica Minolta 7033 Instruction Manual

Section 8 : Special Copying : Page Editing

8. Dual Page

Dual page is used to copy an open book, a large sheet, or two sheets placed side by side
onto two sheets in 1s1 mode, or onto the front and back sides of one sheet in 1s2 mode
to increase manual copying speed.
The following three modes can be selected from the Dual Page Mode Selection screen.
1 Facing Pages mode: Image division starts from the first scan.
2 Front Cover + Facing Pages mode: Image division starts from the second scan, after
the first scan copies normally.
3 Front/Back + Facing Pages mode: Image division starts from the third scan, after the
first and second scan copy normally.
Basic rules for Dual Page
• The Store mode is selected automatically.
Advice
If memory overflow frequently occurs, you are recommended to extend the memory.
Contact your Service Centre.
• Copying mode is either 1s1 or 1s2.
• AMS is automatically selected. APS is incompatible.
Dual Page Specifications
Platen glass to be used (RADF cannot be used in Dual page mode).
Scanned image capacity : 1,500 image max. at a time
Original paper size
Tray paper size
Print quantity
Incompatible
If any of the following copying conditions are going to be set, the Dual page may
be cancelled or the key concerned on the screen may become faint, not allowing
setting.
Using RADF
2s2
2s1
APS
Reserve
Image quality (Very high)
RADF store mode
Sheet/Cover insertion
Set original
: A3, B4, 11"x17"
: A4, B5, 8.5"x11" (80g/m
: 999 sets max.
Combination
Chapter
Image insert
Mixed original
Reverse image
Repeat
Frame erasure
Image shift
1s2 mode
1s1 mode
2
paper recommended)
8. Dual Page
Image Insert
Dual Page
8 - 39