Konica Minolta 7033 Instruction Manual page 137

Section 8 : Special Copying : Page Editing
(4) Touch " OK " key on the Sheet/Cover Insertion Mode Selection screen to display the
Sheet/Cover Insertion Setting screen.
(5) Enter the page number of each insertion location, using the Ten keys of the Operation
panel. The specified page number is displayed on the screen. Touch " SET " key to fix
the entered page number, or touch " DELETE " key to clear.
(6) Repeat step (5) until all the page numbers to be inserted are entered.
Operation panel
DATA
ELP
1
4
ON
7
ORY
P
ET
Advice: Copy Insertion
• In 1s1 mode, for example, if "11" is entered, the 11th page of the 1-sided originals
is copied on the paper in Tray 1 and inserted.
• In 1s2 mode, for example, if "11" is entered, the 11th page of the originals is copied
on the front side and the 12th page on the back side of the paper in Tray 1 and
inserted. Entering "12" will result in the same.
• In 2s2 mode, for example, if "11" is entered, both sides of the 11th page of the
originals are copied on both sides of the paper in Tray 1 and inserted.
• In 2s1 mode, for example, if "11" is entered, only the front page of the 11th page
is copied on the paper in Tray 1 and inserted.
Advice: Blank Insertion
• In 1s1 mode, for example, if "11" is entered, the blank paper in Tray 1 is inserted
after the 11th page of the 1-sided originals is copied.
• In 1s2 mode, for example, if "11" is entered, the blank paper in Tray 1 is inserted
after the 11th page of the originals is copied on the front side and the 12th page on
the back side of the paper. Entering "12" will result in the same.
• In 2s2 mode, for example, if "11" is entered, the blank paper in Tray 1 is inserted
after both sides of the 11th page of the originals are copied on both sides of the
paper.
• In 2s1 mode, for example, if "11" is entered, the blank paper in Tray 1 is inserted
after the page 11 of the 2-sided originals is copied.
Advice
To void the selection, touch "
restored.
(7) Touch " OK " key on the Sheet/Cover Selection screen to return to the Application
Selection screen. Proceed to step 5 .
5. The Application Selection screen will be restored.
6. As required, set the other copying conditions. When copying more than 50 originals,
use RADF store mode or Platen store mode. Touch " Store Mode " key to highlight it.
Advice
To clear all application settings, touch "
7. Touch "
OK " key on the Application Selection screen. The Basic screen will be restored.
8 - 10
ERROR
POWE
ON
2 3
INTE
5 6
STOP
8 9
0
CLEAR QTY. STAR
" key. The Application Selection screen will be
CANCEL
ALL CLEAR
2. Sheet/Cover Insertion (continued)
Sheet/Cover Insertion Setting screen
" key.