Konica Minolta 7033 Instruction Manual page 208

Section 9 : Special Copying: Copy Image
Supplement 1: Using RADF store mode
To copy a set of more than 50 originals, use RADF store mode. Touch and highlight the
" Store Mode " key on the Application Selection screen. See p. 7-8 to p. 7-10 for details.
Please Be Reminded!
Divide the originals into blocks not exceeding 50 sheets and load them from the block
with the first page.
Supplement 2: Checking copying conditions/printed copies
1. Press the CHECK button to display the Check screen.
2. Check the current copying conditions on the Check screen.
3. Touch "
PROOF COPY " key on the Check screen to make a proof copy.
When completed, touch " EXIT " key to return to the Basic screen.
See p. 7-22 to p. 7-27 for details.
2. Press the START PRINT button. Originals loaded on
RADF are all scanned and discharged, then printing job
starts in succession.
When using Store mode, press the START PRINT button
to start the output job.
To stop copying, press the STOP/CLEAR button.
Scanned data in the memory will be cleared.
After completion of copying, all the data in the memory
will be cleared.
Having Problems?
The memory may be fully loaded to cause overflow during
scanning. See p. 12-4 to p. 12-5.
v Place Original(s) on Platen Glass...FACE DOWN / Start Copying
1. Open the RADF.
2. Place the original on the platen glass.
Advice
Be careful of the margin side of the original.
For details of how to place the originals, see p.6-8.
First set original
2
5
8
0
Image shift copying
in simplex mode
2
Binding
1
margin
7. Image Shift (continued)
ERROR
POWER SAVER
ON / OFF
3
INTERRUPT
6
STOP / CLEAR
9
CLEAR QTY. START PRINT
Image shift copying
in duplex mode
1
3
4
3
Binding
margin
9 - 33
Image Shift