Konica Minolta 7033 Instruction Manual page 121

Section 7 : Other Basic Functions
Procedure
1. Set the copying conditions that is to be stored in the memory.
2. Display the Basic screen.
3. Press the JOB MEMORY button on the operation panel. The Job No. Selection
screen will be displayed.
Advice - To Display Help Screen
Pressing the HELP button on the operation panel right after the above operation will
display the Job Memory Instruction screen. Touch "EXIT" to return to the Job No.
Selection screen.
Advice - To Discontinue Job Store Operation
When you wish to discontinue the following operation, press the AUTO RESET button
on the operation panel.
Irrespective of the screen displayed, the Job store operation will be discontinued, and
the Basic screen will be restored.
4. Touch "
ENTRY " on the Job No. Selection screen.
5. The Job Store Check screen will be displayed. The copying conditions set in step
1 will be displayed. Confirm the selections.
Advice - Corrective Setting of Copying Conditions
If the stored contents include any mistake, touch "
screen. The Basic screen will be restored. Newly set the correct copying conditions,
and re-do from step
6. Touch "
OK " key on the Job Store Check screen. The Job No. Selection screen will
be displayed, to show " 1 " to " 5 " of Job No. keys.
If the Upper arrow and
15 job numbers.
7. Touch the desired Job No. key. The selected Job No. key will be highlighted, and
the Name Input screen will be displayed.
At the Job No. key with LOCK mark "
stored, and you can store your conditions.
At the Job No. key with LOCK mark "
are stored, but you can store your new conditions, which will replace those already
stored.
At the Job No. key with LOCK mark "
you cannot store your new conditions.
Advice - Lock of Job No. Key
To lock or unlock the copying conditions stored at a Job No. key, or to delete the locked
copying conditions, see p. 11-28 in "Section 11: KEY OPERATOR MODE".
Advice - Discontinuing Storing at a Job No. Key
When you wish to discontinue your storing at the touched Job No. key, touch "
The Basic screen will be restored while the copying conditions set in step
If you press the AUTO RESET button on the operation panel, the set copying conditions
will also be cleared.
8. Enter a job name in up to 24 characters, using the touch screen alphabet keypad.
If required, scroll with the
case and symbol keys. To correct an entry, touch " DEL. " repeatedly to delete each
character entered, then enter the correct job name.
If you do not wish to enter a name, touch "OK". The key displays [ * * * * * ] in place
of a name.
9. Touch "
OK " key on the Name Input screen. The Job No. Selection screen will be
displayed.
To re-enter the Job name, touch " CANCEL " to return to the Name Input screen.
10. Touch "
OK " on the Job No. Selection screen. The Basic screen will be restored.
7 - 34
3
.
Lower arrow keys can be used to scroll through the
" off but with a name, copying conditions
" lit, the copying conditions are locked and
Upper arrow and
6. JOB MEMORY Button (continued)
CANCEL " on the Job Store Check
" off and without any name, nothing is
Lower arrow key to use lower
".
CANCEL
1
remain set.