Konica Minolta 7033 Instruction Manual page 191

Section 9 : Special Copying: Copy Image
Procedure
z Set Copying Conditions
1. Close the RADF securely and press the AUTO RESET button.
2. Press the APPLICATION button on the Operation panel, to display the Application
Selection screen.
3. Touch "
Frame/Fold Erasure " key on the Application Selection screen. The Frame/
Fold Erasure Mode Selection screen will be displayed.
Application Selection screen
4. Touch "
Frame Erasure " key, then use arrow keys to select the desired frame erasure
amount, from 1~15 mm in 1 mm increments.
Touch " Fold Erasure " key, then use arrow keys to select the desired fold erasure
amount, from 1~30 mm in 1 mm increments.
Touch " Frame Erasure " key and " Fold Erasure " key to copy both modes.
5. Touch "
OK " key to complete the setting. The Application Selection screen will be
restored. As required, set the other copy conditions. When using Store mode, touch
" Store Mode " key on the Application Selection screen.
6. Touch "
OK " key on the Application Selection screen. The Basic screen will be restored.
x Enter Print Quantity
Press the Ten keys to enter the desired print quantity.
To change the entered quantity, press the CLEAR QTY. button and enter the correct
number.
Please Be Reminded!
DO NOT press the STOP/CLEAR button when changing the print quantity. Stored
image will be cleared. Do not press the AUTO RESET button as this will clear all the
copier settings.
Operation panel
ELP
ON
ORY
ET
9 - 16
DATA ERROR
POWE
ON
1 2 3
INTE
4 5 6
STOP
7 8 9
0
P
CLEAR QTY. STAR
4. Frame/Fold Erasure (continued)
Frame/Fold Erasure Mode Selection screen
Basic screen