Konica Minolta 7033 Instruction Manual page 112

Section 7 : Other Basic Copying
1. Touch "
EXIT " from Check mode and return to the Basic screen.
2. Change the copying conditions, as required.
If any condition to be modified cannot be changed, press the STOP/CLEAR button.
All the stored data will be cleared. Press the AUTO/RESET button to return to the initial
settings, then set the copying conditions again.
m Make a Proof Copy/Change Settings
Repeat steps in b and n until you receive a result that you are satisfied with.
, Verify/Change Print Quantity
Proof copy can be operated repeatedly. Since each operation reduces the set print
quantity, re-enter it as required.
. Start Copying
Press the START PRINT button. The copier will output the
rest except the sample set.
If print quantity has been changed, the re-entered number
of copied sets will be output.
To stop printing, press the STOP/CLEAR button. This action
also clears all the scanned data.
After completion of copying, all the data in the memory is
cleared. Press the AUTO RESET button to return to the
initial condition.
4. CHECK Button (continued)
ERROR
POWER SAVER
ON / OFF
2 3
INTERRUPT
5 6
STOP / CLEAR
8 9
0
CLEAR QTY. START PRINT
7 - 25
CHECK Button