Non-Sort Mode - Konica Minolta 7033 Instruction Manual

Section 10 : Output Mode
Advice
When the Finisher is disconnected from the copier before printing, the message "Please
connect finisher to the copier" will be displayed, and if it happens to be disconnected
in the middle of printing, the Jam Position screen will be displayed. Be sure to lock the
Finisher securely to the copier to avoid the above cases.

Non-Sort Mode

The Non-sort mode simply means that the offset-stacker finisher modes are not selected.
Copies will be stacked on the Finisher upper/middle/lower tray without being offset by
sets.
Advice
Usually the Non-Sort mode is factory-set as the initial state. The initial state can be
changed to the Sort, Group, or Staple-sort by Key Operator mode. See p. 11-13 to p.
11-14.
Non-Sort Mode Specifications
Exit tray
Paper size
Paper capacity
Advice
* : A5 size paper is available in horizontal feed (
: Upper (TRAY1), Middle (TRAY 2), Lower (TRAY 3) exit tray
: A3, B4, F4/8.5"x13", A4R, A4, B5R, B5, A5R*,8.5"x11"R,
8.5"x11"
: Upper exit tray
100 sheets (A3, B4, F4/8.5"x13", A4R, A4, B5, B5R, A5R*,
8.5"x11"R, 8.5"x11")
10 sheets (thin/thick paper, OHP transparency film, etc.)
Middle/Lower exit tray
500 sheets (A4R, A4, B5, B5R, 8.5"x11"R, 8.5"x11")
300 sheets (A3, B4, F4/8.5"x13", A5R*)
1. Finisher Specifications (continued)
6
5
4
3
2
1
) only.
Finisher
10 - 3