Konica Minolta 7033 Instruction Manual page 244

Section 11 : Key Operator Mode
Copy Mode [1]
Set Copy mode to occur after power on or after Auto/Reset occurs.
Setting options: RADF; 1-1; 1-2; 2-2; 2-1
Default setting: RADF on, 1-1
Key Operator Mode screen
Procedure
1. While pressing HELP button, turn power ON. Enter a 4-digit key operator password,
then touch " OK " to display the Key Operator Mode screen.
Advice
If an invalid Key operator password is entered, continue by entering the valid 4-digit
password.
2. Touch "
2. Copier Initial " to display the Copier Initial Setting Menu screen, then
touch " 1. Copy mode " to display the Copy Mode Initial Setting screen.
3. Touch the setting you want for the initial condition of the copier.
If 2-2 or 2-1 mode is selected, RADF will also be selected, automatically. In this
case, the RADF must be in a closed position when power is turned ON, or when
Auto/Reset is functioning. Otherwise, the message "Please close RADF" will be
displayed.
4. Touch "
OK " to complete setting and return the Copier Initial Setting Menu screen.
5. If no further changes are required, proceed to step 8 .
6. If other copier initial setting changes are required, touch desired key from
7. If no other copier initial settings are required, touch "
Operator Mode screen.
8. Turn power OFF.
9. Turn the copier power switch back ON to perform copying operations.
Copier Initial Setting Menu screen
3. Copier Initial [2] (continued)
Copy Mode Initial Setting screen
RETURN " to restore the Key
[1] ~ [6] .
Key Operator
Mode
11 - 9