Staple-Sort Mode - Konica Minolta 7033 Instruction Manual

Section 10 : Output Mode

Staple-Sort Mode

The Staple-sort mode is available when the offset-stacker finisher is installed. Use this
mode when you want to offset and staple each copied set.
Each finished set will be offset on the Finisher middle/lower tray from the next copied set.
Advice
If Rotation activates, the stapling position rotates by 90 .
Staple-Sort Mode Specifications
Using RADF
Exit tray
Paper size
Paper capacity
Staple capacity
Staple location
Advice
* : B5R, A5 size paper is available in horizontal feed (
Incompatible
Using Platen glass (available when used in combination with Image insert, Dual
Group
Booklet
Image quality (Very high)
OHP interleave
APS mode in Mixed original
3
2
3
2
3
2
1 oblique staple
(Platen glass is available when used in combination with Plate
store mode.)
: Middle (TRAY 2), Lower (TRAY 3) exit tray
: A3, B4, F4/8.5"x13", A4R, A4, B5R, B5, A5R*,8.5"x11"R,
8.5"x11"
: Paper cannot be discharged on upper exit tray.
Middle/Lower exit tray
500 sheets (A4R, A4, B5, B5R, 8.5"x11"R, 8.5"x11")
300 sheets (A3, B4, F4/8.5"x13", A5R*)
2
: 50 sheets (80g/m ) or 5.0mm thick or less
(Staple capacity is changeable, and may be set to 45, 40,
or 35 by service.)
2
20 sheets (90g/m ) in thick paper mode
(Staple capacity is changeable, and may be set to 25, 15,
or 10 by service.)
: 1 parallel staple
A4R, B5R, A5R
1 oblique staple
A3, B4, A4, B5
2 parallel staples
A3, B4, A4R, A4, B5
page, or Platen store mode)
Repeat
Auto layout
Thick mode in Thin/Thick paper
Non-image area erase
1. Finisher Specifications (continued)
3
2
3
2
3
2
1 parallel staple 2 parallel staples
) and 1 parallel staple only.
3
2
3
2
3
2
Finisher
10 - 9