Konica Minolta 7033 Instruction Manual page 157

Section 8 : Special Copying : Page Editing
Incompatible
If any of the following copying conditions are going to be set, the OHP Interleave
copying may be cancelled or the key concerned on the screen may become faint,
not allowing setting.
Using the Finisher
1s2
2s2
APS
Image quality (Very high)
Interrupt
Sheet/Cover insertion
Procedure
z Load Transparent Film: Multi-Sheet Bypass Tray
Insert a sheet of OHP transparent film of the same size
as that of originals into the Multi-sheet bypass tray.
Please Be Reminded!
DO NOT load OHP transparent films into any other
tray. It will cause paper jam.
x Load Interleave Paper: Tray 1, 2, 3, or 4
Load Tray 1, 2, 3 or 4 with copy paper the same size as that of OHP transparent film.
c Set Copying Conditions
1 . Close the RADF securely and press the AUTO RESET button to set the RADF mode.
2. Press the APPLICATION button on the Operation panel to display the Application
Selection screen.
3. Touch "
OHP Interleave " key on the Application Selection screen. The OHP Interleave
Mode Selection screen will be displayed.
Application Selection screen
4. Touch "
Blank Sheet Interleaving " or " Copy Sheet Interleaving " key.
Advice
To return to the initial condition, touch "
will be restored.
5. Touch "
OK " key on the OHP Interleave Mode Selection screen. The Application
Selection screen will be restored.
8 - 30
6. OHP Interleave (continued)
Chapter
Booklet
Image insert
Mixed original
Repeat
Thin/Thick paper
OHP Interleave Mode Selection screen
" key. The Application Selection screen
CANCEL