Konica Minolta 7033 Instruction Manual page 197

Section 9 : Special Copying: Copy Image
v Start Copying
Press the START PRINT button.
When using Store mode, press the START PRINT button to
start the output job.
To stop copying, press the STOP/CLEAR button. Scanned
data in the memory will be cleared.
After completion of copying, all the data in the memory will
be cleared.
CAUTION: Paper Capacity of the Finisher
The capacity of the Finisher exit tray is listed below. When the total number of
copies in the copy run exceeds the stated capacity, be sure to unload the exit
tray whilst the copier is still copying. Failure to do so will cause the copier to
jam.
The following capacity is for 80g/m
the capacity will be less than the following.
Non-sort mode
Tray 1: 100 sheets/ 10 sheets (thin/thick paper, OHP films, etc.)
Tray 2/3: 500 sheets (A4R, A4, B5R, B5, 8.5"x11"R)
300 sheets (A3, B4, F4/8.5"x13", A5R)
Sort/Group mode
Tray 2/3: 500 sheets (A4R, A4, B5R, B5, 8.5"x11"R)
300 sheets (A3, B4, F4/8.5"x13")
Staple-sort mode
500 sheets max. (A4R, A4, B5R, B5, 8.5"x11"R)
300 sheets max. (A3, B4, F4/8.5"x13", A5R)
CAUTION: Maximum Loading Capacity of the Exit Tray
In the case of the copier without a finisher, the exit tray capacity is 100 sheets.
Be sure to remove the copies from the exit tray while copying before the
maximum capacity is reached. Failure to do so will cause the copier to jam.
After completion of copying, cancel the selected application function.
• To release Auto layout mode, display the Application Selection screen, touch the reversed
" AUTO Layout " key, then touch " OK " key.
• To release all the application functions, display the Application Selection screen and
touch " ALL CLEAR " key.
• To reset copying conditions to the initial condition, press the AUTO RESET button on the
Operation panel.
9 - 22
ERROR
2
5
8
0
2 paper. When copying mixed size originals,
5. Auto Layout (continued)
POWER SAVER
ON / OFF
3
INTERRUPT
6
STOP / CLEAR
9
CLEAR QTY. START PRINT