Konica Minolta 7033 Instruction Manual page 246

Section 11 : Key Operator Mode
Magnification [3]
Set the magnification ratio you initially want to display after the user turns the power on
or after Auto/Reset restores the Initial settings.
Advice
This setting should not conflict with the Initial setting for Paper Tray. For example, if
APS is selected for the initial paper tray setting, a ratio setting other than AMS will be
ignored.
Setting options: AMS; 1.00; ratio 0.25~4.00
Key Operator Mode screen
Procedure
1. While pressing HELP button, turn power ON. Enter a 4-digit key operator password,
then touch " OK " to display the Key Operator Mode screen.
Advice
If an invalid Key operator password is entered, continue by entering the valid 4-digit
password.
2. Touch "
2. Copier Initial " to display the Copier Initial Setting Menu screen.
3. Touch "
3. Magnification " to display the Magnification Initial Setting screen. The
default setting is 1.00.
4. Select the desired setting from the Magnification Initial Setting screen:
To select 1.00 if it is not already displayed, touch " 1.00 ".
To select another ratio, touch upper/lower arrow key to display the desired ratio, or
enter a 3-digit ratio using the keypad on the operation panel.
To select AMS, touch " AMS ".
5. Touch "
OK " to complete the setting and return to the Copier Initial Setting Menu
screen.
6. If no further changes are required, proceed to step 9 .
7. If other copier initial setting changes are required, touch desired key from
8. If no other copier initial settings are required, touch "
Operator Mode screen.
9. Turn power OFF.
10. Turn the copier power switch back ON to perform copying operations.
Copier Initial Setting Menu screen
3. Copier Initial [2] (continued)
Magnification Initial Setting screen
RETURN " to restore the Key
[1] ~ [6] .
Key Operator
Mode
11 - 11