Konica Minolta 7033 Instruction Manual page 213

Section 9 : Special Copying: Copy Image
x Enter Print Quantity
Press the Ten keys to set the desired print quantity.
To change the entered quantity, press the CLEAR QTY. button and enter the correct
quantity.
Please Be Reminded!
DO NOT press the STOP/CLEAR button when changing the print quantity. Stored
image will be cleared. Do not press the AUTO RESET button as this will clear all the
copier settings.
Operation panel
ELP
ON
ORY
ET
c Place Original(s) on the platen glass ...FACE DOWN
1. Open the RADF
2. Place the original on the platen glass.
Please Be Reminded!
DO NOT close the RADF.
Having Problems?
Non image area erase may not operate properly if the lighting in the work place is
directly over the platen glass. In this case, consult your Service Centre about an
appropriate place for installation.
Supplement 1: Using Platen store mode
To use Platen store mode, see p. 7-2 to 7-10 for details.
Supplement 2: Checking copying conditions/printed copies
1. Press the CHECK button to display the Check screen.
2. Check the current copying conditions on the Check screen.
3. Touch "
PROOF COPY " key on the Check screen to make a proof copy.
When completed, touch " EXIT " key to return to the Basic screen.
See p. 7-22 to p. 7-27 for details.
9 - 38
DATA ERROR
POWE
ON
1 2 3
INTE
4 5 6
STOP
7 8 9
0
P
CLEAR QTY. STAR
8. Non Image Area Erase (continued)
Basic screen