Konica Minolta 7033 Instruction Manual page 220

Section 10 : Output Mode
Operation panel
Procedure
1. Press the OUTPUT button on the operation panel to display the Output Mode screen
2. Touch "
SORT ".
3. Touch "
TRAY 2 " or " TRAY 3 ".
Advice
Do not touch " TRAY 1
4. Touch "
OK " to complete setting and return to the Basic screen.
5. Select additional copying features, as desired.
6. Enter the desired print quantity.
7. Position original(s) FACE UP in the RADF.
When using RADF store mode, position originals FACE UP in the RADF and touch
" SCAN " on the Basic screen to scan. Max. 1,500 images can be stored in memory.
When using Platen store mode, position original FACE DOWN on the platen glass
and touch " SCAN " on the Basic screen to scan. Max. 1,500 images can be stored
in memory.
8. Press the START PRINT button to begin copying in Sort mode.
CAUTION: Paper Capacity of the Finisher
The capacity of the Finisher exit tray is listed below. When the total number of
copies in the copy run exceeds the stated capacity, be sure to unload the exit
tray whilst the copier is still copying. Failure to do so will cause the copier to
jam. The following capacity is for 80g/m
Sort Mode
Tray 2/3 : 500 sheets (A4R, A4, B5R, B5, 8.5"x11"R)
300 sheets (A3, B4, F4/8.5"x13", A5R)
CAUTION: Finisher Operation
DO NOT INSERT your finger into the two staple driving Portions or into the
grooves of the paper exit lever, otherwise you may be injured.
To avoid injury when the Finisher middle exit tray moves up and down, DO
NOT PUT your hand into the two portions of the closing area.
10 - 6
OUT PUT
" to select the Sort mode.
1. Finisher Specifications (continued)
Output Mode screen
2
paper.